Top 10 reasons to join NETSCOPE CCNA Career Program

1. Cisco Certified Trainers
2. Certificate of Attendance from NETSCOPE
3. Highly Equipped Cisco Lab
4. Approved by Ministry of Education UAE
5. Customize Corporate Training
6. Cisco Exam Preparation
7. Free Course Repeat Policy
8. Real world Scenarios Based Training
   

Course Overview

Cisco Certified Network Associate (CCNA®) validates the ability to install, configure, operate, and troubleshoot medium-size route and switched networks, including implementation and verification of connections to remote sites in a WAN. CCNA curriculum includes basic mitigation of security threats, introduction to wireless networking concepts and terminology, and performance-based skills. This new curriculum also includes (but is not limited to) the use of these protocols: IP, Enhanced Interior Gateway Routing Protocol (EIGRP), Serial Line Interface Protocol Frame Relay, Routing Information Protocol Version 2 (RIPv2),VLANs, Ethernet, access control lists (ACLs).

Target Audience

Computer Engineering Students, Networking Professionals and System Engineer.

Course Duration
Hours:45- Instructor Led Course

CCNA Exam
200-120 CCNA

Course Outline

Module 1

1. Fundamentals of Networking
a. OSI layers
b. TCP/IP layers
c. Identifying Router and Switch IOS Software
d. Cable, Ports and Connectors to connect Cisco Network Devices

Module 2
1. IP addressing
a. IPv4 addressing
b. Subnetting
c. VLSM - Variable Length Subnetting Mask
d. Super netting

Module 3
1. Router Management
a. Identifying Router Components and accessories
b. Connecting to a Cisco Router and Switches via Console
c. Router Password Set and Reset
d. Configuring Switch Password Reset
e. Assigning IP address on an interface
f. Interface Specific Configurations
g. Loopback interface
h. Login , EXEC and MOTD Banners
i. Copy Command
j. Cisco Device Initial Configuration
k. Basic Password Authentication
l. Password Encryption Service
m. Configuring exec timeout and Login Failure Rate

Module 4
1. IP Routing
a. Configuring Static Routing
b. Configuring a Floating Static Route
c. Configuring a Static Default Route

Module 5
1. Routing protocol
2. RIP
a. Configuring Routing Information Protocol(RIP) version1 and Version 2
b. Metric Calculation
c. Configuring RIP Timers
d. Configuring RIP Interface Options
e. Passive-interface Default
f. Route Summarization
g. RIP Default Information Originate
h. RIP Route Metric - Distance Command
3. EIGRP
a. Configuring Basic EIGRP
b. Metric Calculation
c. EIGRP split Horizon
d. EIGRP stub Area Networs
e. EIGRP Timers
g. Passive-interface default
h. Summarization
4. OSPF
a. Basic OSPF
b. OSPF Neighborship
c. OSPF Timers
d. Metric Calculation - Cost
e. Passive-interface Default
f. OSPF maximum-paths
g. Summarization
h. OSPF Stub Areas

Module 6
1. Route Redistribution
a. Static Route Redistribution
b. Mutual OSPF and RIP Redistribution
c. Mutual OSPF and EIGRP Redistribution
d. Mutual EIGRP and RIP Redistribution

Module 7
1. Access-list and NAT
a. Standard Access-list
b. Extended Access-list
c. Numbered and Named Access-list
d. Static NAT
e. Dynamic NAT with Overloading
f. Dynamic NAT with PAT

Module 8
1. Switching Concepts
a. VLAN's
b. Configuring Access Modes
c. Configuring Trunk interface using ISL and dot1q encapsulation
d. Vlan Trunking Protocol (VTP)
e. VTP Pruning
f. Inter-vlan Routing(Router-on-a-Stick)
g. STP - Spanning-Tree Protocol
h. Rapid-STP, PVST, PVST+, MST
i. Spanning-Tree Features - POrtfast, BPDUGuard, BPDUFilter
Module 9
1. WAN Technologies
a. Configuring WAN interface with PPP or HDLC encapsulation
2. Basic Of Frame-Relay

Module 10
1. MPLS
a. Introduction to MPLS.
b. Label Stack
c. LDP and TDP peer
d. Layer3 MPLS Table - LFIB
e. MPLS ping and Traceroute

Module 11
1. IPv6
a. Introduction to IPv6
b. IPv6 Addressing
c. IPv6 Static Routing
d. IPv6 RIPng
e. IPv6 OSPFv3
f. IPv6 EIGRPv6
g. IPv6 Access-list

Module 12
1. IP services and IP security
2. Cisco IOS DHCP Server
a. Configuring DHCP on cisco routers
b. Introduction to NTP
c. NTP Server
d. NTP Client
e. Cisco IOS DNS Name Servers

Exam Preparation
During class trainer prepare students questions of CCNA exam 200-120 so they can easily passe online CCNA exam.

Call Now for Free Seminar or Registration

Office # 949 9 Floor Damas Building Tel: +9716-561-8305 Sharjah UAE Mobile(yawar)

+971555386380